banner-product

JUNHE®2550 Monocrystalline cell texturing auxiliary additives

Short Description:

JUNHE®2550 monocrystalline texturing auxiliary additive is a crystalline silicon solar cell texturing auxiliary product. It is a water-soluble, non-toxic and harmless additive that meets environmental protection requirements. This product improves the etching selectivity ratio of inorganic alkali to silicon and forms a micron-level pyramid texture on the surface of the silicon wafer, thereby achieving a good light trapping effect.


Product Detail

Product Tags

Product Features

1、High environmental protection level

Selective etching can be achieved without the use of alcohol products such as IPA.

2、Low production cost

The addition amount is low, the texturing time only takes 6 to 8 minutes, and the cost is much lower than the IPA texturing process.

3、Significantly efficiency improvement

Compared with the IPA texturing process, the texture uniformity and reflectivity are better.

4、No initial polishing process

The cost is greatly reduced, and the additive itself is more environmentally friendly.

Technical Parameters

Compositions

Contents

CAS No.

EC No.

Pure water

95 - 97 %

7732-18-5

231-791-2

Sodium lactate

2 – 2.5 %

532-32-1

220-772-0

Sodium epoxysuccinate

1-1 . 5 %

51274-37-4

/

Surfactant

0 . 01 - 0 . 05 %

/

/

Preservative acid

0 . 1 % - 0 . 2 %

137-40-6

205-290-4

Application Range

This product is generally suitable for Perc, Topcon and HJT battery processes

Suitable for single crystals of 210, 186, 166, and 158 specifications

Physical Features

No.

Item

Main parameters and project indicators

1

Color, shape

Dark brown liquid

2

PH value

13-14

3

density

1.1-1.9g/ml

4

Storage conditions

Store at room temperature away from light

Instructions

1、Add an appropriate amount of alkali (1.5 - 2.5% based on the volume ratio of KOH (48%)) into the tank.

2、Add an appropriate amount of this product (0.5 - 0.8% by volume) into the tank.

3、Warm the texturing tank liquid to 80℃+4.

4、Put the silicon wafer into the texturing tank, and the reaction time is 400s-500s.

5、Recommended weight loss for a single film: 0.45 + - 0.06 g (210 film sources, other film sources are converted in equal proportions).

Use Case

Taking Jiejia Veichuang trough-type texturing equipment as an example, the non-primary polishing process is used

Process tank

 

Pure water

Alkali (45%KOH)

Addition(JUNHE®2550)

Time

Temperature

Weight lose

Texturing

First liquid dispensing

437.5L

6 L

2.5 L

420second

82℃

0.47±0.03gram

Liquid infusion

9L

500 ML

180 ML

Precautions

1、Additives need to be stored strictly away from light.

2、When the production line is not producing, the fluid should be replenished and drained every 30 minutes. If there is no production for more than 2 hours, it is recommended to drain and refill the fluid.

3、New line debugging requires process matching according to each process of the production line to maximize efficiency. The recommended process can be referred to debugging.


  • Previous:
  • Next:

  • Write your message here and send it to us